Hand held Controllers

Single Track Hand Held Controller with Feedback* for most small Gauges. *Not recommended for use with coreless design motors. May not be suitable for use with some DCC ready locomotives.

Input: 1 x 16v A.C. at a maximum of 1.25 amps (Gaugemaster T1, M1 or 100M recommended, requires a GM75 6 Pin DIN Plug to connect to 100M, sold seperately)

Output: 1 x 12v D.C. at 1 amp controlled
Fitted with 1.5 metres of 4 core cable

Measurements: 75mm x 50mm x 27mm deep
Discount Price

Single Track Walkabout Controller for 'N', 'OO' and most small Gauges

Input: 1 x 16v A.C. at 1.25 amps (Gaugemaster T1, M1 or 100M recommended, requires a GM75 6 Pin DIN Plug to connect to 100M, sold seperately)

Output: 1 x 12v D.C. at 1 amp controlled
Fitted with 1.5 metres of 4 core cable

Measurements: 109mm x 68mm x 20mm deep
Discount Price

Single Track Walkabout Controller with Simulation for ‘N’, ‘OO’ and most small Gauges. This unit is similar to Model W but has simulation which is operated by a wheel control on the side of the unit. The simulation can be switched on or off as required. Speed is controlled by the control knob and the direction changes by 3 position centre off switch.

Input: 1 x 16v A.C. at 1.25 amps (Gaugemaster T1, M1 or 100M recommended, requires a GM75 6 Pin DIN Plug to connect to 100M, sold seperately)

Output: 1 x 12v D.C. at 1 amp controlled

Fitted with 1.5 metres of 4 core cable

Measurements: 109mm x 59mm x 20mm deep
Discount Price