Other Products

Electronic Automatic Single Track Cleaner for use with all types of controllers. The unit superimposes a harmless high frequency signal over the output from the controller. When a poor contact between loco and rail is detected the unit switches on, ionising the gap and burning off the dirt, switching off again when contact is restored.

Input: 16v A.C. at a maximum of 1.25 amps (Gaugemaster T1 or M1 recommended)

Specification: The HF-1 is compatible with the SS-1, SS-2 and SS-3

Measurements: 75mm x 60mm x 27mm
Discount Price

Electronic Automatic Twin Track Cleaner for use with all types of controllers. This unit works in the same way as the single track unit above, with the facility for a second track.

Input: 16v A.C. at a maximum of 1.25 amps (Gaugemaster T1 or M1 recommended)

Measurements: 109mm x 68mm x 20mm

Specification: The HF-2 is compatible with the SS-1, SS-2 and SS-3
Discount Price

A time controlled unit which can be used with any controller and stops a locomotive at a point on a line, reverses it and then stops it again at a second point, reversing the locomotive again. This repeats indefinitely. The duration of each sequence can be adjusted from approx 20-70 seconds.

Input: 16v A.C. at a maximum of 1.25 amps (Gaugemaster T1 or M1 recommended)

Measurements: 109mm x 68mm x 20mm
Discount Price

A small unit providing an automatic stop and start facility which only requires one reed switch to be installed. The locomotive decelerates for about 5 seconds after passing the reed switch and stops for approximately 20 seconds as factory set. The time stopped can be adjusted from approx 20-70 seconds, the rate of deceleration is also adjustable. Reed switch and magnet are included.

Input: 16v A.C. at a maximum of 1.25 amps (Gaugemaster T1 or M1 recommended)

Measurements: 109mm x 68mm x 20mm
Discount Price

This unit is designed to allow two locomotives to be run on one circuit of track yet not collide with one another due to different running speeds. Two aspect colour light signals (two wire only eg. HBYS) can be installed at each section and bypass switches can be added allowing locomotives access to sidings if required. A soft start and stop has been incorporated for realism.

Input: 16v AC at a maximum of 1.25 amps (Gaugemaster T1 or M1 recommended)

Measurements: 118mm x 116mm x 41mm
Discount Price